Call-us on: +86-318-60632121

Chain Link Fence Machine

Chain link fence machine for manufacturing chain link fences of different sizes. The wire is taken in from the payoff stand and passed through the dies where the DIAMOND SIZE takes place. Different gap sizes. After passing from the die the diamond pattern wire is automatically thrown on the winding shaft in the stitching process. Once the stitching is complete the woven is manually glided down to enable the next stitch to take place.

The chain link is automatically wound to form rolls when the desired length is manufactured.
The machine is controlled by PLC automatic controller, so only one person is needed to operate it.
One side or both sides of the end of net hole is twisted or with burr in edge.
Use compacting machine to make it into rolls For more information, please contact us.

Mechanical Propertie
Width scope of weaving 0.5 - 4m
Diameter of wire 2 - 5mm (depend on the mesh size)
Mesh Size 30 - 80mm
Speed of the axle of shaped knife 275 - 1100rpm (variable speed)
Power consumption five motors, altogether in 8.9kW
The output per minute If the mesh is 50 × 50mm, width: 2m, the output will be: 1m/2min.
Suitable wire to the machine The tensile scope of the wire 300 - 500N/M
Weight of equipment 4200kg
Outside size 6700 × 1430 × 1800mm

Your inquiry will be highly appreciated!
Jinda will service for you !
E-mail: asales@gabionmachine.com

Please provide the detail requirements when inquiry to us. It will helps to give a satisfactory answer.